SmartMoto.Asia / EasyRide
EasyRide — Keyless Ignition Module for Motorbikes
A Bluetooth-based start authorization unit wired into the motorbike ignition circuit. Replaces the physical key for daily riding.
01
What it is
EasyRide is an electronic control unit wired in parallel with the stock ignition switch. When a paired phone is detected nearby, the system automatically permits the ignition circuit; a double press of the starter button then starts the engine.
The original ignition key remains fully functional after installation. EasyRide adds a Bluetooth authorization layer without removing or replacing the existing system.
When the phone is unavailable, a personal 3-digit PIN entered via the starter button authorizes the ignition.
02
Compatibility
The system is designed for 12 V motorbikes with a standard ignition key — no factory keyfob and no chip-based immobilizer — equipped with an electric starter.
Not compatible with motorbikes that have factory keyless/keyfob or a chip-key immobilizer.
For models not listed, consult a mechanic before ordering.
Phone: Android and iOS with Bluetooth Low Energy support.
03
How to use
Pair your phone
Open Bluetooth settings, find EasyRide-XXXXXX, pair using the 6-digit code in the instruction sheet. Done once.
Start the engine
Sit on the motorbike. Two quick presses of the starter button — ignition on. Then press starter with brake held — normal engine start.
Switch off
Two presses of the starter button with the brake released — ignition off.
Backup start — PIN
If the phone is unavailable or dead: hold starter button 3 s → tap each PIN digit in sequence → hold again 3 s.
Phone-out-of-range warning
If you ride away without the phone, the system sounds alerts at approximately 5, 15 and 30 s. The engine is not shut off while riding.
04
Specifications
| Supply voltage | 12 V DC |
| Standby current | < 2 mA |
| Wireless interface | Bluetooth Low Energy (BLE) |
| Simultaneously paired phones | 1 |
| Backup authorization | 3-digit PIN via starter button |
| Encryption | 128-bit |
| Enclosure protection | IP68 |
| Warranty | 2 years (no mechanical damage) |
05
Kit contents
- 01Electronic control unit — 1 pc.
- 0230 cm connector harness — 1 pc.
- 03Universal relay — 1 pc.
- 041 m wires for custom routing — 2 pcs.
- 05Wire terminals — 10 pcs.
- 06Plastic cable tie — 1 pc.
- 07Instruction sheet with personal PIN and pairing code — 1 pc.
06
Installation
EasyRide is wired in parallel with the stock ignition switch via the relay included in the kit. Installation does not require cutting or modifying the factory wiring.
Typical installation time is 30–60 minutes. An owner with basic wiring skills (can identify positive and negative, has a screwdriver, wire cutters and tape) can install it independently.
If unfamiliar with motorbike electrical systems, a mechanic is recommended.
07
Frequently asked questions
Order
Price: 40 USD
2-year warranty. 30-day returns.